AutoDiscovery server system requirements

This topic describes minimal and recommended system requirements for the AutoDiscovery server in A32.10.

License requirements

A valid license (AppViz (with AutoDiscovery)) is required.

Back to top

Supported deployments per architecture structure

The following table lists the supported deployment models for the AutoDiscovery server.

Deployment Supported?

AlgoSec Hardware Appliance (2XX3 series)*

✔

Virtual Appliance (VMware)**

✔

ASMS on AWS (AMI)

✔

ASMS on Azure

✖

* Only AlgoSec Hardware Appliances 2203 and 2403 are compatible with A32.10.

  • AlgoSec Hardware Appliance 2063 requires RAM Upgrade. Contact your sales representative​.
  • 2XX2 Hardware Appliances – EOL by Oct. 2021​: Not supported. Contact your AlgoSec sales rep to discuss options.​
  • 2XX1 Hardware Appliances - EOL: Not supported. Contact your AlgoSec sales rep to discuss options.

** VMware Motion is not compatible with AlgoSec.

*** When deployed on AWS, any Load Units must also be located in AWS, in the same subnet as the Central Manager.

Back to top

Hardware requirements

Note: When the AutoDiscovery server is hosted on a Remote Agent, the Remote Agent is dedicated to AutoDiscovery. It may not be used to manage devices.

See Hardware minimum requirements for Remote Agents.

If you are deploying additional sensors, system requirements for the sensor installations may depend on the traffic collection method. For more details, see Deploy additional AutoDiscovery network sensors.

Tip: If you have issues decoding HTTP(s) because the certificate is unavailable, we also recommend using the sensor installed together with the AutoDiscovery server, instead of installing remote sensors.

Back to top

AutoDiscovery required ports

Traffic between AutoDiscovery components uses the following ports. They must be open on the AutoDiscovery server and all remote AutoDiscovery sensors:

  • TCP/9545. The port that the Network Sensor uses to listen for server requests.
  • TCP/9645. The port that the Log Sensor uses to listen for server requests.

Ports used to send statistic network traffic data to the sensors, usually:

  • UDP/2055 for NetFlow
  • UDP/6343 for Sflow

Back to top